Part WB Sweep Tool GUI Improvement [Solved]

Have some feature requests, feedback, cool stuff to share, or want to know where FreeCAD is going? This is the place.
Forum rules
Be nice to others! Read the FreeCAD code of conduct!
Post Reply
frcaduser
Posts: 321
Joined: Wed Apr 07, 2021 11:22 pm

Part WB Sweep Tool GUI Improvement [Solved]

Post by frcaduser »

Version 0.20.2
Rev. # 29603 (Git)
Release Date 2022/12/07 02:35:37
OS Windows 10 Version 2009
Word Size 64-bit

Hello,

after using the Sweep tool from the Part wb a few times, I think that it can be improved by prompting you to
enter both the profile and the edge at the same time as opposed to prompting you to enter the items one at a
time. In its current form, after you enter the profile, it then prompts you to enter the edge. After having done
so, which button do you select, the Done or the Ok?

To simplify and improve the GUI, both items should be entered at one time. If both entries are valid, then an Ok
button is highlighted (turns green) signifying that the conditions have been met to proceed.


frcaduser
Post Reply