So I created a sketch, drew a circle, and constrained it to 76.2 mm. I pad that to 4.7mm. I create another sketch (in the same body), draw a circle, constrained it to 55.56mm, and pad the sketch to 14.28mm. I then create a subtractive cylinder, 25.4mm in radius, 14.28mm deep (on the xy plane I think, I don't understand fully the dialog that opens up).
I get this error when I try to add a fillet:
Code: Select all
23:12:02 Part::Fillet: Link(s) to object(s) 'Cylinder' go out of the allowed scope 'Fillet'. Instead, the linked object(s) reside within 'Body Body'.
23:13:01 1e-07 <App> Document.cpp(3216): The graph must be a DAG.
23:13:01 0.175947 <App> Document.cpp(3571): __inch_wire_grommet_flange#Fillet still touched after recompute
23:13:01 0.177074 <App> Document.cpp(3216): The graph must be a DAG.
23:13:01 Part::Fillet: Link(s) to object(s) 'Cylinder' go out of the allowed scope 'Fillet'. Instead, the linked object(s) reside within 'Body Body'.
23:13:01 Recompute failed! Please check report view.
23:15:28 147.289 <App> Document.cpp(3216): The graph must be a DAG.
23:16:21 200.109 <App> Document.cpp(3216): The graph must be a DAG.
23:16:43 Recompute failed! Please check report view.
23:17:14 Recompute failed! Please check report view.
23:17:43 Recompute failed! Please check report view.
23:17:59 Recompute failed! Please check report view.
23:18:39 Recompute failed! Please check report view.
23:21:00 Recompute failed! Please check report view.
23:21:08 Recompute failed! Please check report view.
23:32:12 Recompute failed! Please check report view.
23:36:29 <Exception> Tree.cpp(2005): Dependency loop detected for Unnamed#Pad001
23:37:36 <ShapeBinder> ViewProviderShapeBinder.cpp(363): invalid selection
23:39:23 Recompute failed! Please check report view.
I also cannot export the drawing to an STL. I think the two pad operations are not bound to each other or something but honestly, this is all beyond me. I have no background in CAD and I have only been learning CAD/FreeCAD for a few weeks. Any help would be appreciated.