Beso Macro V's System Macros? / Measure

Have some feature requests, feedback, cool stuff to share, or want to know where FreeCAD is going? This is the place.
Forum rules
Be nice to others! Read the FreeCAD code of conduct!
Post Reply
Imagine
Posts: 31
Joined: Sun Mar 05, 2023 12:18 pm

Beso Macro V's System Macros? / Measure

Post by Imagine »

Hello FC,
In regards to the Beso Macro,
I find myself having to choose macro's location over and over again. The system & User Macros have separate file locations correct & will that overcome this?

I find Beso is best if you start the analysis with a fresh master file every time also a little inefficient.

In the attached file a simply supported I-Beam, the strong spots where Beso has removed material could support load as this would be the best location. Which led to wondering is there a way to measure INP file or mesh in general. The only work around I can think of is superimposing geometry over the mesh, & then measuring. However perhaps not the best method for high tolerance.
Attachments
Screenshot_Beso_FC_Measure.png
Screenshot_Beso_FC_Measure.png (269.55 KiB) Viewed 299 times
Post Reply