No you can't modify a tutorial and pretend it is working as expected.pauljurczak wrote: ↑Fri Mar 24, 2023 3:49 pm ...
Which part of my question in initial post was unclear? Have you read it carefully before posting? That rule applies to both sides.
And probably you are not aware that the tutorial is for Part Design so Sketcher is not the right WB to be used.
Do not blame helpers if they tell you are wrong, if you want quality answers you should make good questions.
Tutorial was made on 0.20 and checked on a clean FreeCAD installation with a clean user directory.
I doubt that @Roy_043 has not checked the workflow.
Regards
Carlo D.