- Workbench Draft
- Workbench Manipulator
- Workbench QuickMeasure
- Macro FCInfo
Perhaps there is an add-on that displays the main parameters of the selected object in the status bar?
How to determine what are main parameters?demonlibra wrote: ↑Fri Mar 24, 2023 5:03 am During the use of FreeCAD, I found the following ways to measure the parameters of circles:All of these methods require too many steps to get such basic information.
- Workbench Draft
- Workbench Manipulator
- Workbench QuickMeasure
- Macro FCInfo
Perhaps there is an add-on that displays the main parameters of the selected object in the status bar?
screemshot.png
An other one :demonlibra wrote: ↑Fri Mar 24, 2023 5:03 am
- Workbench Draft
- Workbench Manipulator
- Workbench QuickMeasure
- Macro FCInfo
Good solution, but takes up a whole line in the panel.
Hope for a bright future.
you can set the Width of the ToolBar or move it instead of the status bar