I understand your concerns, but I think that such information doesn’t belong to the wiki’s tool description but rather into a milling tutorial. Or should we add some kind of tutorials section to the tools? That may require a general decision.Russ4262 wrote: ↑Tue Mar 21, 2023 12:16 am I recommend that the suggested solutio not be to adjust the diameter of a tool, but use a reasonable value for "Stock to Leave" and then following the Adaptive op with a Profile op to finish the side walls. I think this is more in line with how a machinist might mill the part, using the Adaptive op for clearing, then a Profile and possible Pocket/Surface op for the final finish.
In real life I would live with the 0.001 mm offset and see it as a premature compensation of the tool wear .