feedback: the new message window may be nice for raising visibility of some messages but it's getting real annoying popping up worthless warnings about G0 feed rates. The message window stays up quite a long time and masks the status bar which I need to refer to constantly for coordinate readout when working on paths.
In the past I've managed to skip over these messages in the report view , which seems a suitable place for them.
Code: Select all
20:17:44 Base.WARNING: Tool Controller feedrates required to calculate the cycle time.
20:17:44 Base.WARNING: Tool Controller feedrates required to calculate the cycle time.
20:17:44 Base.WARNING: Tool Controller feedrates required to calculate the cycle time.
I could set feed rates but I don't care and don't want to waste time doing this for every tool in every job. I just let the machine do G0 at its default fastest speed for that axis. I don't want to check what the machine can do and mirror it here. If I tune the machine faster or slower, I don't want to start rewriting all my gcode files to keep them in sync. This is a waste of time.
Please get these banal warnings out of my work flow, like it used to be.
TIA.