[Feature Request] FEM Analysis as a variable, instead of fixed solution

About the development of the FEM module/workbench.

Moderator: bernd

Post Reply
SmileyFaceImoji
Posts: 10
Joined: Mon Jun 27, 2022 10:09 am

[Feature Request] FEM Analysis as a variable, instead of fixed solution

Post by SmileyFaceImoji »

Hello FreeCad community

basically I was creating a structural model and performed a stress analysis on this part, then yesterday I realized a way to design it so it would take up less space, and basically the analysis broke since the meshes were no longer the same.

The request is, why not have the meshes, written inp file and therefore the ccx results be a variable connected to the part or body and if any changes occur you simply refresh the whole analysis and it will edit the inp file and other results and not all be fixed to what is written at the time
Post Reply