bernd wrote: ↑Tue Nov 01, 2022 4:19 pm
It would be cool if you would have an eye on it if there are miss takes in there in the new BluesScope profiles.
I will start looking at them over the next few days Bernd and keep you updated. Thanks very much to you and Moult.
bernd wrote: ↑Tue Nov 01, 2022 4:19 pm
It would be cool if you would have an eye on it if there are miss takes in there in the new BluesScope profiles.
I have upgraded my installation of Bolts and had a quick look at a couple of CHS profiles. I think the way the Lysaghts tables are set out may have caused a problem. Please compare that table with the Australian Tube Mill table both of which are attached.
Perhaps you could send me the Bolts CHS template so I can delve into it a bit further.
Attachments
Lysaghts CHS Table.png (39.01 KiB) Viewed 988 times
Austube Mills Table.png (148.87 KiB) Viewed 988 times