I don't remenber that launching Path wb, we alos see the preferences of Part/PartDesign.
the wiki doesn't say that.
@kaktus to inform you too in case of we need to open a PR.
preferences of Path launch also Part/PartDesign preferences
Forum rules
Be nice to others! Respect the FreeCAD code of conduct!
Be nice to others! Respect the FreeCAD code of conduct!
Re: preferences of Path launch also Part/PartDesign preferences
open FreeCAD and launch only Path wb.
go to the Preferences. I don't expect to also see the preferences of Part/PartDesign: Path_Preferences doesn't talk about that and I don't remember that too but as I am not a user, only translator, I am not sure.
Re: preferences of Path launch also Part/PartDesign preferences
There was some rearrangement of the Preferences over the past couple of months, so any changes are likely the result of that adjustment.
I think Part WB is always active, so the Part/PartDesign Preferences will always appear.
I do not believe the Path WB has any role in this behavior.
Gene
I think Part WB is always active, so the Part/PartDesign Preferences will always appear.
I do not believe the Path WB has any role in this behavior.
Gene
Re: preferences of Path launch also Part/PartDesign preferences
Path uses something from PartDesign and thus it is imported and shows in the preferences. This can happen with other workbenches too, and may be worth mentioning in the wiki, but it can also be seen as some implementation detail which you don't have to worry about.
A Sketcher Lecture with in-depth information is available in English, auf Deutsch, en français, en español.
Re: preferences of Path launch also Part/PartDesign preferences
I don't really worry only wanted to clarify (my memory can play with me).
GeneC has more or less answer to my questionning.
thank you for your feedback.
GeneC has more or less answer to my questionning.
not necessary, if you launch Arch Wb, Draft preferences are shown too but not Part ones for ex. same thing with Mesh wb.
thank you for your feedback.