Version 0.20.2
Rev. # 29603 (Git)
Release Date 2022/12/07 02:35:37
OS Windows 10 Version 2009
Word Size 64-bit
Hello,
I am attempting to apply a draft angle to an enclosure by using the draft tool from the Part Design workbench. If I apply the draft angle to the enclosure from the inside, it will work as highlighted by the screenshot attachment. However, still receiving the error 'Adding face failed on
Face9. Omitted.' When I attempt to apply the same draft angle but on the outside surface, I get the same error, but the draft angle is not
applied.
Note that the neutral plane is the top perimeter surface.
Why would the draft tool not work for the outside surface?
frcaduser
Part Design: Draft Angle Tool [Solved]
Forum rules
and Helpful information
and Helpful information
IMPORTANT: Please click here and read this first, before asking for help
Also, be nice to others! Read the FreeCAD code of conduct!
Also, be nice to others! Read the FreeCAD code of conduct!
Part Design: Draft Angle Tool [Solved]
- Attachments
-
- draftAngleInside_01.png (19.4 KiB) Viewed 218 times
-
- enclosureDraftAngle.FCStd
- (32.54 KiB) Downloaded 11 times
-
- draftAngleInside.png (28.96 KiB) Viewed 251 times