Along the advice from chrisb, jeno and papyblaise, further progress was made in 'hardening' and cleaning the basic model:
- Flipping of sides in the sketch after recomputing:
This now is avoided by rearranging the constraints / design suitably. The major measure was to draw a point(s) attached to the main coordinates to start with, where lines are constrained to afterwards. These points would not flip.
- Dynamic main fillet radii set to zero:
There is a conditional workaround in the spreadsheet now. Both are set to 0,001mm, if a zero-angle is desired for the CAD-model
- The spreadsheet was edited to remove small errors and increase readability
Many thanks!
Here is how its lookig now:
I very much would appreciate the advice of you experienced people for the next (and hopefully last?) piece of workflow.
How (which tools) and in which state of the model would you draw the additional second set of cutouts (parallel and symmetrical to the first set) ? These can not be included in the mirrorings, since they are not symmetrical.
Hope you find some time!