How to make linear massive without intersection from parameter?
I'm use two metods:
1) create massive PartDesign - LinearPattern
This doesn't fit becouse not create not intersection massive
2) create massive Draft - OrthogonalArray
This doesn't fit becouse not use parametric function
Linear massive without intersection from parameter?
Forum rules
and Helpful information
and Helpful information
IMPORTANT: Please click here and read this first, before asking for help
Also, be nice to others! Read the FreeCAD code of conduct!
Also, be nice to others! Read the FreeCAD code of conduct!
Re: Linear massive without intersection from parameter?
Don't know what a massive is, sorry.
Perhaps try a tutorial;-
https://wiki.freecad.org/Creating_a_sim ... PartDesign
Perhaps try a tutorial;-
https://wiki.freecad.org/Creating_a_sim ... PartDesign
Re: Linear massive without intersection from parameter?
Hello dima8101, greetings to the Community!
I don't understand your request, moreover you should attach at least one file to check, and importantly you should enter the data relating to your system and the version of FC you are using, as specified in the regulation.
The attached file contains two ways of creating Arrays, the first created with the "Part Design" tools (plates in view) the second with the "Draft" tools (subtracted plates).
- Attachments
-
- Array.FCStd
- (33.26 KiB) Downloaded 5 times
-
- Array.png (145.56 KiB) Viewed 475 times
Re: Linear massive without intersection from parameter?
I can't set an array of bodies if there is a distance between the bodies. I need a parametric distance setting.
I did it through the menu items: PartDesign - LinearPattern
I did it through the menu items: PartDesign - LinearPattern
Re: Linear massive without intersection from parameter?
You need to use an expression. Expressions
The interval can be written as (Occurrences-1) * 50mm (interval in mm) or somesuch.
The interval can be written as (Occurrences-1) * 50mm (interval in mm) or somesuch.
- Attachments
-
- Interval.FCStd
- (18.91 KiB) Downloaded 4 times
Re: Linear massive without intersection from parameter?
I formulated the task incorrectly.Bance wrote: ↑Fri Mar 24, 2023 2:27 pm You need to use an expression. Expressions
The interval can be written as (Occurrences-1) * 50mm (interval in mm) or somesuch.
I don't need a rectangle. Therefore, if you delete it, then the proposed solution does not work.
- Attachments
-
- 005.png (73.86 KiB) Viewed 335 times
Re: Linear massive without intersection from parameter?
There is a single solid rule for Bodys, that's why it is not possible in PartDesign, you would need a common base (which you could remove later).
In draft you cannot use expressions when using the task panel, but after its reation, you can well use them on the properties.
In draft you cannot use expressions when using the task panel, but after its reation, you can well use them on the properties.
A Sketcher Lecture with in-depth information is available in English, auf Deutsch, en français, en español.
Re: Linear massive without intersection from parameter?
Hello dima8101, greetings to the Community!
Attached is a small example of dynamic parameterization (obtained using the "DynamicData" Wb), obviously it can be made more modifiable by adding further parameters and references.
- Attachments
-
- dynamic_parameterization_with_arrays.FCStd
- (14.33 KiB) Downloaded 5 times
-
- Dynamic_parameterization_with_arrays.gif (272.64 KiB) Viewed 278 times