Thanks again.
I am trying to go through everything on the machine and see what I am missing, as well as going and checking the model in the file I uploaded.
I must be missing something silly, but I thought they were 1.125." That's what the constraints are listed as in the underlying sketch. Though I am the first to admit that I am a complete newbie at this.
Can't find the right toolpath
Forum rules
Be nice to others! Respect the FreeCAD code of conduct!
Be nice to others! Respect the FreeCAD code of conduct!
-
- Posts: 9
- Joined: Fri Jan 27, 2023 11:59 pm
-
- Posts: 9
- Joined: Fri Jan 27, 2023 11:59 pm
Re: Can't find the right toolpath
I thought I would update the thread. I figured out why I was having a dimensioning issue. It was a silly bonehead mistake: I thought the ballscrews on my machine were .2" pitch, but they are 5mm (.197") pitch. Changed the steps/inch in Mach4 to 10,140 instead of 10,000 and it works like a dream.