Museum Work

Show off your FreeCAD projects here!
Forum rules
Be nice to others! Respect the FreeCAD code of conduct!
mario52
Veteran
Posts: 4673
Joined: Wed May 16, 2012 2:13 pm

Re: Museum Work

Post by mario52 »

Hi
Bernardo wrote: Wed Feb 01, 2023 11:48 am What i'd like to have? A measure tool to calculate the length of an arc.
have you tried:

Manipulator_Workbench Image general move and info

QuickMeasure

Macro_FCInfo Image length of arc, radius, if it is bspline the approximate radius on point is displayed and many other info

Macro_FCInfo_ToolBar Image mini FCInfo in a toolBar you configure only what you want display

if you want other options then ... juste demander
Bernardo wrote: Wed Feb 01, 2023 11:48 am Ancient Greek architecture - at its peak - was very sophisticated in its modification of geometric primitives. Looking at a Greek temple you might perceive column shafts as cones and are positioned vertically, entabulatures as perpendicular blocks and so on. They are not. You might look at these sketches (not from me) to see the the basic idea.
http://www.enzyklopaedie.ch/dokumente/D ... tempel.jpg
https://external-content.duckduckgo.com ... ipo=images
incredible !!!

mario
Maybe you need a special feature, go into Macros_recipes and Code_snippets, Topological_data_scripting.
My macros on Gist.github here complete macros Wiki and forum.
thschrader
Veteran
Posts: 3129
Joined: Sat May 20, 2017 12:06 pm
Location: Germany

Re: Museum Work

Post by thschrader »

Bernardo wrote: Wed Feb 01, 2023 11:48 am ...
What i'd like to have? A measure tool to calculate the length of an arc.
Go to Arch-wb, activate the "Survey" tool (the blue helmet).
You can measure length, area, volume. Works with Spline curves too...
The lower left corner of the blue marker indicates the center of gravity.
surveyTool.JPG
surveyTool.JPG (37.79 KiB) Viewed 591 times
Bernardo
Posts: 13
Joined: Wed Feb 08, 2017 12:20 pm

Re: Museum Work

Post by Bernardo »

OK, got it. Thx all.
Post Reply