I did a check of the case and tried to run a new mesh session but somehow - I have nothing changed on my system so far and dependencies check was also OK - I got the following error message when triying to mesh:
0.0: Preparing meshing ...
0.0: Exporting mesh refinement data ...
0.1: Error TypeError: 'int' object is not subscriptable
What the heck is going on now ?
Does anybody bring the simulation attached to run
Moderator: oliveroxtoby
Forum rules
and Helpful information for the FEM forum
and Helpful information for the FEM forum
-
- Posts: 114
- Joined: Wed Apr 17, 2019 2:08 pm
-
- Posts: 114
- Joined: Wed Apr 17, 2019 2:08 pm
Re: Does anybody bring the simulation attached to run
Ha, meanwhile I found the mistake. One Face was wrong numbered in the wall boundaries.