meshing - mesh is generated on cylinderical shape and NOT the actual part (cylinder)
Moderator: oliveroxtoby
Forum rules
and Helpful information for the FEM forum
and Helpful information for the FEM forum
-
- Posts: 7
- Joined: Wed Dec 29, 2021 11:02 pm
Re: meshing - mesh is generated on cylinderical shape and NOT the actual part (cylinder)
I am sorry I forgot to enclose the FreeCAD file - here it is
- Attachments
-
- cyl.FCStd
- (809.18 KiB) Downloaded 32 times
-
- Posts: 7
- Joined: Wed Dec 29, 2021 11:02 pm
Re: meshing - mesh is generated on cylinderical shape and NOT the actual part (cylinder)
All - I finally solved this secondary (yellow) meshed square long block.
This meshed yellow thing shows up If I do not click "Write mesh case" and directly if I go to "Run mesher" then if you to "load surface mesh" you will what I saw this yellow meshed thing and the part remain "unmeshed". Then if you see in Paraview it just shows that yellow meshed thing - dummy- there.
The procedure is to first save "Write mesh case", next "Run mesher" then "load surface mesh" - then "Paraview"
An elementary mistake.
Thank you all..
This meshed yellow thing shows up If I do not click "Write mesh case" and directly if I go to "Run mesher" then if you to "load surface mesh" you will what I saw this yellow meshed thing and the part remain "unmeshed". Then if you see in Paraview it just shows that yellow meshed thing - dummy- there.
The procedure is to first save "Write mesh case", next "Run mesher" then "load surface mesh" - then "Paraview"
An elementary mistake.
Thank you all..