Hello. I know this is not the place to write, but could someone help me draw this geometric figure for my subject "fundamentals of construction and AutoCAD"
I just have no idea how this is going to happen, apart from the circles of course. Please help me.. and again sorry for not being on the forum rules..
Where it says "ф" is diameter.
Construction of a geometric figure.
Forum rules
Be nice to others! Respect the FreeCAD code of conduct!
Be nice to others! Respect the FreeCAD code of conduct!
Construction of a geometric figure.
- Attachments
-
- 20221101_105334.jpg (413.69 KiB) Viewed 1154 times
- Shalmeneser
- Veteran
- Posts: 9475
- Joined: Wed Dec 23, 2020 12:04 am
- Location: Fr
Re: Construction of a geometric figure.
- Attachments
-
- Capture du 2022-11-02 01-48-25.png (45.52 KiB) Viewed 1126 times
-
- Fundamentals_SHALM.FCStd
- (45.64 KiB) Downloaded 26 times
Re: Construction of a geometric figure.
Thanks very much. Now I will try to draw it..
Re: Construction of a geometric figure.
Greetings to the Community!
.... the dimension of axonometry.
I would like to clarify that any modification to the solid geometry and / or to the TechDraw elaborate (including cosmetics) can cause distortions in the dimensioning.
.... the dimension of axonometry.
I would like to clarify that any modification to the solid geometry and / or to the TechDraw elaborate (including cosmetics) can cause distortions in the dimensioning.
- Attachments
-
- Axonometric dimensioning in TechDraw.FCStd
- (102.14 KiB) Downloaded 24 times
-
- Axonometric dimensioning in TechDraw.png (213.92 KiB) Viewed 970 times
Re: Construction of a geometric figure.
Judging by the way the arrows are located, the rounding is equal to five.