TechDraw - Can't make faces

[user1234]

In fact my direction is 0.05, -1, 0 and my x-direction is 0, 0, -1. What should I replace these values with to keep the same view but make them positive?

I made a small mistake in my comment. I mean a leading minus before a value of a zero (example: -0.00000 . This is often a sign, that the projection is not correctly aligned.

Hi, file is too large to upload here but I have shared it using Google Drive. Can you please check if you can access it?

All Parts are rotated in the the 3D space (but not 100% ident). Also the some parts have defects. Also many parts for the drawing collides. This all does not like the OCCT kernel. Be happy, that you only have the "no face" error.

0.png (118.68 KiB) Viewed 459 times

1.png (226.26 KiB) Viewed 459 times

It looks like you're trying to add a vertical centerline between two horizontal lines. I would pick two vertical lines for references.

in my FreeCAD version (0.20master), it takes the correct direction automatic. But it computes heavily. I think it is because auf the geometry issues.

0.png (118.68 KiB) Viewed 459 times

.


Greetings
user1234