Przesunięcie przy PolarPattern zależne od kąta

Polish forum

Moderators: PrzemoF, kaktus

Forum rules
Regulamin forum i pomocne informacje

WAŻNE! Przeczytaj zanim poprosisz o pomoc
Post Reply
User avatar
JackkDBA
Posts: 60
Joined: Tue Jan 04, 2022 7:43 am
Location: Poland
Contact:

Przesunięcie przy PolarPattern zależne od kąta

Post by JackkDBA »

Hej!
Chcę sobie w walcu zrobić np. 20 otworów. Ważne jest jednak, aby były one nie na 1 płaszczyźnie, ale przesunięte na osi Z zgodnie z funkcją sinus * amplituda_przesunięcia, a dokładnie tak:
- otwór 1: przesunięcie = sin(0 * 360/20) * amplituda_przesunięcia = 0
- otwór 2: przesunięcie = sin(1 * 360/20) * amplituda_przesunięcia = sin(18deg) * amplituda_przesunięcia
- otwór 3: przesunięcie = sin(2 * 360/20) * amplituda_przesunięcia = sin(36deg) * amplituda_przesunięcia
- itd.

Jak to osiągnąć? Nie widzę w PolarPattern takiej opcji :roll: Mam wersję 0.20.1,

Pozdrawiam,
Jacek
Best regards,
Jacek
User avatar
JackkDBA
Posts: 60
Joined: Tue Jan 04, 2022 7:43 am
Location: Poland
Contact:

Re: Przesunięcie przy PolarPattern zależne od kąta

Post by JackkDBA »

Dokładam plik FreeCAD-a:
test1.FCStd
(239.54 KiB) Downloaded 79 times
Last edited by JackkDBA on Thu Nov 09, 2023 5:20 am, edited 2 times in total.
Best regards,
Jacek
chrisb
Veteran
Posts: 53922
Joined: Tue Mar 17, 2015 9:14 am

Re: Przesunięcie przy PolarPattern zależne od kąta

Post by chrisb »

Don't crosspost. You should wait a reasonable time before reposting in another forum, where "reasonable" is much more than 20 minutes.
A Sketcher Lecture with in-depth information is available in English, auf Deutsch, en français, en español.
User avatar
NewJoker
Veteran
Posts: 3018
Joined: Sun Oct 11, 2020 7:49 pm

Re: Przesunięcie przy PolarPattern zależne od kąta

Post by NewJoker »

Draft PathArray pozwala umieszczać kopie wzdłuż dowolnej krzywej.
Post Reply