Hej!
Chcę sobie w walcu zrobić np. 20 otworów. Ważne jest jednak, aby były one nie na 1 płaszczyźnie, ale przesunięte na osi Z zgodnie z funkcją sinus * amplituda_przesunięcia, a dokładnie tak:
- otwór 1: przesunięcie = sin(0 * 360/20) * amplituda_przesunięcia = 0
- otwór 2: przesunięcie = sin(1 * 360/20) * amplituda_przesunięcia = sin(18deg) * amplituda_przesunięcia
- otwór 3: przesunięcie = sin(2 * 360/20) * amplituda_przesunięcia = sin(36deg) * amplituda_przesunięcia
- itd.
Jak to osiągnąć? Nie widzę w PolarPattern takiej opcji Mam wersję 0.20.1,
Pozdrawiam,
Jacek
Przesunięcie przy PolarPattern zależne od kąta
Przesunięcie przy PolarPattern zależne od kąta
Best regards,
Jacek
Jacek
Re: Przesunięcie przy PolarPattern zależne od kąta
Dokładam plik FreeCAD-a:
Last edited by JackkDBA on Thu Nov 09, 2023 5:20 am, edited 2 times in total.
Best regards,
Jacek
Jacek
Re: Przesunięcie przy PolarPattern zależne od kąta
Don't crosspost. You should wait a reasonable time before reposting in another forum, where "reasonable" is much more than 20 minutes.
A Sketcher Lecture with in-depth information is available in English, auf Deutsch, en français, en español.
Re: Przesunięcie przy PolarPattern zależne od kąta
Draft PathArray pozwala umieszczać kopie wzdłuż dowolnej krzywej.