I have 2 sections i want to create a solid between the 2 sketches, which works fine as a loft, but i need to control the loft with 2 guide curves, the bottom edge is flat/planar, the top edge is a radius.
i have used additive pipe which works but again only allows 1 guide curve
i am used to using much higher end Cad systems (CATIA, NX, Solid Edge, Solid Works...), and this is simple to do.
But i am a total Newbie on Freecad
Thanks for any help
Freecad 0.20
Rev 29177
Red Hat
64 Bit
Is it possible to loft with 2 Guide rails
Forum rules
and Helpful information
and Helpful information
IMPORTANT: Please click here and read this first, before asking for help
Also, be nice to others! Read the FreeCAD code of conduct!
Also, be nice to others! Read the FreeCAD code of conduct!
Re: Is it possible to loft with 2 Guide rails
Try the curved shapes addon from addon manager...
Re: Is it possible to loft with 2 Guide rails
Thanks, can you suggest which command to use, so i can find out if it will do what i want before i add it on
Re: Is it possible to loft with 2 Guide rails
Just add it. It takes up almost no resources.
Star Trek II: The Wrath of Khan: Spock: "...His pattern indicates two-dimensional thinking."
Re: Is it possible to loft with 2 Guide rails
If you don't like the addon its easily removed. They are modules.