PolarPattern with Z-axis shift depending on the function of angle
Forum rules
and Helpful information
and Helpful information
IMPORTANT: Please click here and read this first, before asking for help
Also, be nice to others! Read the FreeCAD code of conduct!
Also, be nice to others! Read the FreeCAD code of conduct!
Re: PolarPattern with Z-axis shift depending on the function of angle
Eventually found a solution. Fantastic is Lattice2.
- Attachments
-
- Capture2.JPG (23.49 KiB) Viewed 224 times
-
- Special_PolarPattern.FCStd
- (185.28 KiB) Downloaded 12 times
-
- Veteran
- Posts: 3111
- Joined: Thu Sep 24, 2020 10:31 pm
- Location: Hawaii
- Contact:
Re: PolarPattern with Z-axis shift depending on the function of angle
I found a way, using your parametric curve - but I needed to make an array of vertical construction lines at the cylinder locations. Otherwise I could not figure out how to get the correct attachment there.
- Attachments
-
- Special_polarpattern_EW.FCStd
- (121.62 KiB) Downloaded 12 times