funerary chapel
Posted: Mon Oct 11, 2021 9:44 pm
Hello!
I wanted to share some images of a project that took quite long to develop, actually the last 3 years. FC was used to verify the construction drawings of the precast concrete builders, and to be able to visualize the step files coming from the sheet metal workshop.
The concrete model was built using Draft and Part WBs, while the Sheet Metal panels were drawn in 2d with Draft, sent to the workshop and imported through step. (We could also have designed them in SheetMetal, but you know, if someone else can do it better than you... )
Here is a small axonometric drawing obtained with TechDraw and a little bit of inkscape.
The model is quite dirty and not complete, cause it was mainly designed in 2d, and the drawings were continuously modified along the experimentations and construction, to check and verify the architectural choices.
you can checkout the result here: https://www.designboom.com/architecture ... 0-11-2021/
I wanted to share some images of a project that took quite long to develop, actually the last 3 years. FC was used to verify the construction drawings of the precast concrete builders, and to be able to visualize the step files coming from the sheet metal workshop.
The concrete model was built using Draft and Part WBs, while the Sheet Metal panels were drawn in 2d with Draft, sent to the workshop and imported through step. (We could also have designed them in SheetMetal, but you know, if someone else can do it better than you... )
Here is a small axonometric drawing obtained with TechDraw and a little bit of inkscape.
The model is quite dirty and not complete, cause it was mainly designed in 2d, and the drawings were continuously modified along the experimentations and construction, to check and verify the architectural choices.
you can checkout the result here: https://www.designboom.com/architecture ... 0-11-2021/