Construction of a storage platform.

[thomas-neemann]

construction of a storage platform. I am open to suggestions for improvement.

phpBB [video]

anschluss.FCStd

(688.46 KiB) Downloaded 52 times

[thschrader]

OK Thomas, lets rock.
Lets do steel-engineering!
What about the beam connections?
Can you show a workflow with connections?

Dimension of the connection plates. Which bolts?
The most difficult part.

You use profiles which cant produced in the real world.
No rounding between flange/web ( in german: Ausrundung zwischen Flansch/Steg fehlt).
Why dont you use the boltsFC makro for profiles?

Working fast is one point, working correct is another.

To be clear: I like your work!

Can you post a fast workflow with all details?

My words sounds like rant.
This is not my intention.

[thschrader]

This is a current project we are working on.
The steel-frame must be boltet at the concrete walls of the
elevator engine-room. No building plans available, only a rough
measurement at the site. I need a horizontal/vertical tolerance-compensation,
like the clamp. Spreading the profiles over a sketch works fast, but
the "fun" beginns with the connections.

Would be cool if you could show a fast workflow including the
connections to your storage-frame.

pic001.JPG (78.9 KiB) Viewed 1577 times

[thomas-neemann]

Thanks for the feedback. complete agreement. I will go into the subject further. Freecad also has profiles with rounded shapes, but so far I have not been able to model them "directly".

here is a video with more details, screws etc:


https://forum.freecadweb.org/viewtopic.php?f=24&t=57105