sorry, didn't read everything
Draft is not showing the correct angle dimension
Forum rules
Be nice to others! Respect the FreeCAD code of conduct!
Be nice to others! Respect the FreeCAD code of conduct!
- thomas-neemann
- Veteran
- Posts: 11921
- Joined: Wed Jan 22, 2020 6:03 pm
- Location: Osnabrück DE 🇩🇪
- Contact:
Re: Draft is not showing the correct angle dimension
Re: Draft is not showing the correct angle dimension
I discovered that the part measure angular also gives the wrong dimension.
However if you draw a line over the sketch line, then delete the sketch you get the correct angles.
However if you draw a line over the sketch line, then delete the sketch you get the correct angles.
- Attachments
-
- p1.png (33.45 KiB) Viewed 286 times