A2Plus reapply constraints

Discussion about the development of the Assembly workbench.
Forum rules
Be nice to others! Respect the FreeCAD code of conduct!
Post Reply
saltedfish
Posts: 6
Joined: Sun Dec 26, 2021 12:10 am

A2Plus reapply constraints

Post by saltedfish »

I applied some constraints to two parts, then used the "Move part under rule of constraints" and now the part is in a different place? I'm not sure why the part would move if it's constrained.
chrisb
Veteran
Posts: 53926
Joined: Tue Mar 17, 2015 9:14 am

Re: A2Plus reapply constraints

Post by chrisb »

Moved to Assembly.
A Sketcher Lecture with in-depth information is available in English, auf Deutsch, en français, en español.
kisolre
Veteran
Posts: 4163
Joined: Wed Nov 21, 2018 1:13 pm

Re: A2Plus reapply constraints

Post by kisolre »

Only if it is fully constrained. For example if you have two parts wit just a single axisCoincident constraint between them don't you expect at least one of them to be able to move along that axis?
Post Reply