Post Pipeline display scale

About the development of the FEM module/workbench.

Moderator: bernd

Post Reply
Rikus
Posts: 2
Joined: Thu May 17, 2018 5:30 am

Post Pipeline display scale

Post by Rikus »

Hi, I am running a FEM on a optical mirror for self deflection. The FEM results are fine surface deformation in the nm range (+68nm and -53nm) typical. I need to display the deformation image in a gray scale as per the Post Pipeline option, but it only goes to 6 decimals. As a result it does not display the surface correctly. Is there a way to set the limits smaller? I am not confident scaling everything up will provide the correct results
User avatar
NewJoker
Veteran
Posts: 3018
Joined: Sun Oct 11, 2020 7:49 pm

Re: Post Pipeline display scale

Post by NewJoker »

The easiest way might be to export the results to vtk file and postprocess them using ParaView.
Post Reply