Hello,
First of all I would like to thank you for such an amazing software.
I have a problem making finite element analysis for an assembly, I made an assembly consisting of 3 parts and i want to assign different material for each part. I tried Boolean union to mesh the assembly as a whole and I referenced material for each solid in the assembly. CalculiX .inp file got written but when i run it , it gives this error "*ERROR in calinput: no material was assigned". Can anyone help me?
Assigning two different materials.
Moderator: bernd
Forum rules
and Helpful information for the FEM forum
and Helpful information for the FEM forum
Assigning two different materials.
- Attachments
-
- Assembly.FCStd
- (11.79 KiB) Downloaded 24 times
-
- Posts: 31
- Joined: Sat Sep 24, 2022 3:52 pm
Re: Assigning two different materials.
Hello FemDyn
here an tutorial what I made it is for plastic material and with FC 19 but the workflow for material should be the same
for linear analysis then you don't have to do the steps with selection the non linear material and a setting of nonlinear
stress and strain values at the INP.
Here a link to the complete discussion
https://forum.freecadweb.org/viewtopic. ... 0&p=469803
Greetings Nanayaw
here an tutorial what I made it is for plastic material and with FC 19 but the workflow for material should be the same
for linear analysis then you don't have to do the steps with selection the non linear material and a setting of nonlinear
stress and strain values at the INP.
Here a link to the complete discussion
https://forum.freecadweb.org/viewtopic. ... 0&p=469803
Greetings Nanayaw
- Attachments
-
- FEM_Material_Selection.pdf
- (186.59 KiB) Downloaded 37 times
-
- Simulation_4Parts_4Materials_Linear_Static Setup.pdf
- (499.83 KiB) Downloaded 39 times