Part Designにて、以下のバージョンで件名の事象が発生します。
バージョン: 0.21
リビジョン: 30430 (Git)
リリース: 2022/09/21 19:44:35
<再現手順>
1. XY平面にSketchで50x50mmの正方形を描画
2. 作成したスケッチを、Padで50mm押し出す。50x50x50mmの立方体ができる。
3. XY平面にSketchで50x25mmの長方形を描画
4. Step 3のスケッチと、長方形の任意の頂点を選択
5. 減算ロフトを実行
6. 立方体の面に対し、データム平面を作成する。
この結果、ボディー表示が消えます。
なぜボディー表示が消えるかご存じの方はいらっしゃいますか?
減算ロフトの後にデータム平面を作るとボディー表示が消える
- Shalmeneser
- Veteran
- Posts: 9560
- Joined: Wed Dec 23, 2020 12:04 am
- Location: Fr
Re: 減算ロフトの後にデータム平面を作るとボディー表示が消える
I confirm.
If then you show the loft (space-bar), there is no more problem : creation of DatumPlane do not hide the object.
Imho it's not normal (but perhaps I have seen it before, don't remember).
If then you show the loft (space-bar), there is no more problem : creation of DatumPlane do not hide the object.
Imho it's not normal (but perhaps I have seen it before, don't remember).
- Attachments
-
- DatumPlaneForInvisibility.FCStd
- (12.54 KiB) Downloaded 72 times
Re: 減算ロフトの後にデータム平面を作るとボディー表示が消える
コメントありがとうございます。
space-barを押すと表示・非表示を切り替えられることは知りませんでした。
ボディー表示が消える事象が起きたときは、その方法で回避したいと思います。
space-barを押すと表示・非表示を切り替えられることは知りませんでした。
ボディー表示が消える事象が起きたときは、その方法で回避したいと思います。