The toolpath is fine as far as accuracy but has way too much redundancy cutting the upper layer surface contours 3 times over while working down thru the cut depths.
Is there a way to set this up to eliminating the overcuts?
I have tried using the optimize step over transitions but it just cuts below the specified cut depth. this might work with an additional finishing toolpath single pass but its an awkward solution?
This is by no means an impasse but it would be nice to find a workaround.
thanks again for all the help. dkw
The toolpath file in question is AT17 right inner face zzmp 50
Code: Select all
OS: Windows 10 Version 2009 Word size of FreeCAD: 64-bit Version: 0.20.29177 (Git) Build type: Release Branch: releases/FreeCAD-0-20 Hash: 68e337670e227889217652ddac593c93b5e8dc94 Python 3.8.10, Qt 5.15.2, Coin 4.0.1, Vtk 8.2.0, OCC 7.6.2 Locale: English/United States (en_US) Installed mods: * Curves 0.3.0 * Help 1.0.3 * ocl.pyd