FreeCAD Forum

juergen01 wrote: ↑Tue Apr 16, 2024 9:26 am Bei Fasteners-Bauteilen funktioniert ja leider Polar-Pattern nicht.

Da gibt es Draft->Polar Array.

thomas-neemann wrote: ↑Tue Apr 16, 2024 9:21 am das ist ein guter wert, welche cpu ist eingebaut?

Die ist glaube ich gar nicht so dolle: 2,6 GHz 6-Core Intel Core i7

ezequielleonzybert wrote: ↑Mon Apr 15, 2024 3:45 pm The dxf exporter is converting arcs to a bunch of straight lines.

Here the arc is converted to a B-spline curve:

I don't understand these "noses" you have. Without them you could make the pad longer ("thicker") then fillet all edges and finally cut top and bottom off so that you have sharp edges again.
This would even be toponaming safe.

Thanks for the feedback, I probably missed a topic on this. Could it be a cascading sticky button (is that the correct term?) like the two modes of arc creation and the two modes of circle creation? In both those cases, the icon changes according to the option selected, so the point could turn from ...

fudel wrote: ↑Mon Apr 15, 2024 10:38 pm Also Form aus Dreiecksnetz erstellen, Form nähen, Genauigkeit 0,1mm.

MacBook Pro: unter 9 Minuten.

Confirmed.
Opening this reply message took already 10 seconds.

The best way is to think before you start. It is by far not always trivial, but worth every minute you think about where to place your object in 3D space. This one should have YZ-plane go through the center of the object.

Glyn wrote: ↑Tue Apr 16, 2024 2:05 am Are there other ways to ensure the cube is centered XYZ?

If you use a Cube primitive or a Part cube, you can use expressions for the x-, y- and z-component of the Placement/AttachmentOffset, e.g. for x:

Code: Select all

-Cube.Length/2

In Cura you have to configure the infill of solids.
100%: plastic rock solid
20%-30%: common infill, pretty stable
12%-20%: rather lightweight
0%: no infill.

Search found 53153 matches

Re: Innengewinde mit der Part-Design WB

Re: Neue CPU? Benötige mal einen Vergleich an einem STL-Modell

Re: How to rotate a sketch drawing

Re: Workflow for creating LOTS of flexures.

Re: Regression on Sketcher Points

Re: Neue CPU? Benötige mal einen Vergleich an einem STL-Modell

Re: Forum very very slow (again)

Re: Best way to center objects

Re: Create 2 rotations of a linked pocket/sketch

Re: Help making object solid